Avanti DW183W Dishwasher User Manual


 
6
¾ Prepare Hot Water Line
The line may enter from either side, rear or floor within the shaded area shown in figure.
The line may pass through the same hole as the electrical cable and drain hose. Or, cut an
additional 1½” dia. Hole to accommodate the water line. IF power cord with plug is used, water
line must not pass through power cord hole.
Water Line Connection
Turn off the water supply.
Install a hand shut-off valve in an accessible
location, such as under the sink. (Optional, but
strongly recommended and may be required by
local codes.)
Water connection is on the left side of the
dishwasher. Install the hot water inlet line, using
no less than 3/8” O.D. copper tubing. Route the
line as shown in figure and extend forward at least
19” from rear wall.
Adjust water heater for 120ºF to 150ºF
temperature.
Flush water line to clean out debris.
The hot water supply line pressure must be
20-120PSI.
¾ Prepare Electrical Connection
This dishwasher should be properly grounded for your safety. The power cord of this dishwasher
is equipped with a ground lead which can connect to your grounded permanent wiring system.
Improper connection of the equipment-grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or service representative if you are in doubt whether the
appliance is properly grounded.
Do not under any circumstances cut or remove the third ground lead from the power cord
supplied.
Remove house fuse or open circuit breaker before beginning installation. Never use an extension
cord or adapter plug with the unit.
Never use a two-prong grounding adapter.
Where a two-prong wall receptacle is encountered, contact a qualified electrician to have it
replaced with a 3-prong receptacle in accordance with applicable electrical codes.
This dishwasher requires a standard 110/120Volts A.C.~/60Hz electrical power, and connected to
an individual properly grounded branch circuit, protected by a 15 or 20 ampere circuit breaker or
time delay fuse.
The cord should be secured behind the dishwasher and not left exposed or dangling to prevent
accidental injury.
aWARNINGa
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized Avanti Products service center.
WARNING
The electrical installation shown below must be performed by a qualified and
licensed electrician, following all of the electrical codes and ordinances
required by the State.