Avanti MKB42B Toaster User Manual


 
11
COOK-TOP
Place your cooking pan on the desired burner.
Push the OPERATION selector to the COOKTOP position.
Turn the BURNER selector to the desired position.
Turn the TIMER selector knob to your desired cooking time. Then range top will operate.
There are three different types of dual burner combinations for your choice (See graphic below).
After using your range top, turn both the TIMER and BURNER selector knobs to the
/
position.
Push the OPERATION selector to the OFF position.
Note: Do not use pans with a diameter less than that of burner. It is advisable to use pans, which have
flat bottom of good thickness. The burners should not be used without a pot or pan on them. If any
liquid spillage occurs it is recommended to wait for the burners to cool down then wipe with a cloth.
Burners are not ON
RIGHT BURNER
ONLY (500W)
LEFT BURNER
ONLY (900W)
BOTH BURNERS
WORKING
(1400W)
CARE AND MAINTENANCE
Cleaning Your Appliance
Before cleaning your appliance, unplug it and allow it to cool.
Remove the crumb tray, wire rack and drip/baking pan.
Use a damp cloth to wash the inside with warm water and a mild detergent. Do not Immerse in Water!
Abrasive cleaners, scrubbing brushes and chemical cleaners may damage the continuous clean coating
on this unit.
Wash the crumb tray, wire rack, drip/baking pan and metal handling tool with a mild detergent solution.
The glass oven door should be cleaned regularly with a non-abrasive liquid cleaner.
Rinse with a damp cloth and then a dry one.
The outside of the appliance should be cleaned with mild detergent and warm water.
CAUTION
Failure to unplug the appliance could result in electrical shock or personal injury.
Storing Your Appliance
Allow the appliance to cool completely before storing. If storing the appliance for long periods of time
make certain that the appliance is clean and free of food particles. Store the appliance in a dry location
such as on a table or countertop or in a cupboard shelf. Other than the recommended cleaning, no
further user maintenance should be necessary.