Avanti MO1400SST Microwave Oven User Manual


 
8
INSTALLATION INSTRUCTIONS
? BEFORE USING YOUR APPLIANCE
? Remove the exterior and interior packing.
? Check to be sure you have all of the following parts:
? Glass Tray
? Roller Ring
? Instruction Manual
? Inspect the oven after unpacking for any visual damage such as:
? Misaligned Door
? Damaged Door
? Dents or Holes in Door Window and Screen
? Dents in Cavity
If any of the above is visible, DO NOT use the oven.
? INSTALLATION OF YOUR APPLIANCE
? When positioning the microwave oven, it should be set on a flat, steady surface.
? Do not block air vents. If they are blocked during operation, the oven may overheat and
eventually cause oven failure.
? Poor television reception and radio interference may result if the oven is located close to a TV,
radio, antenna, or antenna wire. Position the oven as far from them as possible.
? Clean the interior surface with lukewarm water using a soft cloth.
? Keep the oven away from hot air, steam or splashing liquids when choosing a place to locate it,
otherwise, the unit’s operation may be adversely affected, causing it to break down.
? Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption.
? Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
? DO NOT place anything on the top of the oven.
? Keep the oven at least 5 inches away from both sidewalls and away from rear wall to ensure the
proper ventilation.
? DO NOT remove the turn-table drive shaft.
? SAFETY PRECAUTIONS
PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE
MICROWAVE ENERGY
(a) Do not attempt to operate this oven with the door-open since open-door operation can result in
harmful exposure to microwave energy. It is important not to defeat or tamper with the safety
interlocks.
(b) Do not place any object between the oven front face and the door or allow soil or cleaner residue
to accumulate on sealing surfaces.
(c) Do not operate the oven if it is damaged. It is particularly important that the oven door close
properly and that there is no damage to the : (1) Door ( bent ), (2) Hinges and latches ( broken or
loosened ), (3) Door seals and sealing surfaces.
(d) The oven should not be adjusted or repaired by anyone except properly qualified service
personnel.