Filter
Top Products
7
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR MICROWAVE OVEN
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
• Glass Tray
• Turntable Roller Assembly (Roller or Roller Ring)
• Built-in Trim Kit
• Instruction Manual
• Inspect the oven after unpacking for any visual damage such as:
• Misaligned Door
• Damaged Door
• Dents or Holes in Door Window and Screen
• Dents in Cavity
If any of the above is visible, DO NOT use the oven.
FREE STANDING / COUNTERTOP INSTALLATION
OF YOUR MICROWAVE OVEN
(For Built-in Installation, see Installation Guide included with the installation kit).
• When positioning the microwave oven, it should be set on a flat, steady surface.
• Do not block air vents. If they are blocked during operation, the oven may overheat and
eventually cause oven failure.
• Poor television reception and radio interference may result if the oven is located close to a TV,
radio, antenna, or antenna wire. Position the oven as far from them as possible.
• Clean the interior surface with lukewarm water using a soft cloth.
• Keep the oven away from hot air, steam or splashing liquids when choosing a place to locate it,
otherwise, the unit’s operation may be adversely affected, causing it to break down.
• Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption.
• Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
• DO NOT place anything on the top of the oven.
• Keep the oven at least 5 inches away from both sidewalls and away from rear wall to ensure the
proper ventilation.
• DO NOT remove the turn-table drive shaft.