Avanti RM4550W Refrigerator User Manual


 
10
appropriate for home or office use.
? To turn the appliance off, turn the temperature control to0”.
NOTE:
? Turning the temperature control to 0 position stops the cooling cycle but does not shut off the
power to the unit.
? If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
? Using Your Ice Cube Tray
? Recommended thermostat setting for ice making is position 5.
? Fill the ice cube tray (two thirds of it) with cold water or with any liquid suitable
for freezing and place the tray on the bottom of the chiller compartment to
freeze properly.
? Dry the tray, otherwise it may stick to the bottom of the chiller.
? The best method to get ice cubes out of the tray is to hold the tray under cold
tap water for a second.
? To eject the ice cubes from the tray, place over the ice bucket and twist slightly
? The Chiller Compartment
? This compartment is designed for production of ice cubes and short-term storage (3-4 days at
most) pf some commercially frozen foods.
? The temperature in this compartment does not get cold enough to freeze food safely for long
periods of time and works best when the food is already frozen.
? Be design, this chiller compartment is not a true freezer, and may not keep ice cream frozen, or
freeze items.
? A colder setting may be used for these items, but other items in the refrigerator may also be
affected.
? The chiller door is susceptible to breaking due to excessive ice build up. This part is not covered
under your warranty. Be sure to defrost when the ice reaches 1/4 inch thick.
CARE AND MAINTENANCE
? Defrosting Your Unit
? Defrost the unit when the frost accumulated on the evaporator is about 5mm (1/5 inch) thick. Set
the thermostat dial to 0 position.
? Remove frozen or perishable foods from the appliance and place it in a cooler to protect the food.
? During the defrost cycle, the ice melts into the water collection tray.
? To remove the water, either remove the water collection tray and/or place a collection container
under the tray.
? Dry the water collection tray and place back under the appliance compartment. Defrosting
usually takes a few hours. After defrosting, return the thermostat dial to the desired position. To
defrost quickly remove all foods from the unit and leave the door open. Never use a knife or other
metal instrument to scrape ice/frost from the evaporator.
? Cleaning Your Unit
? Turn the temperature control to "0", unplug the unit, and remove the food, shelves, and trays.
? Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
? Wash the shelves and trays with a mild detergent solution.
? The outside of the unit should be cleaned with mild detergent and warm water.
? Wring excess water out of the sponge or cloth before cleaning the area of the controls, or any
electrical parts.