Filter
Top Products
8
IT WILL TAKE APPROXIMATELY 1 HOUR TO REACH OPTIMUM TEMPERATURE. IF YOU CONSUME ONE 8 OZ.
CUP THE RECOVERY TIME IS APPROXIMATELY 25 MINUTES OR LESS. IF YOU CONSUME 2 OR MORE 8 OZ.
CUPS RECOVERY TIME CAN TAKE UP TO 1 HOUR.
o Turn the cold and hot water switches ON (at the rear).
o Now you are ready to use your water dispenser.
NOTE: Your water dispenser has been cleaned and sanitized before leaving the factory, but in case a
taste problem develops, place one tablespoon of baking soda and add tap water. Fill water tank again
and repeat basic operations previously outlined.
OPERATING YOUR WATER DISPENSER
Electrical Connection
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of
electrical shock.
Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products
service center.
This appliance requires a standard 115/120 Volts A.C. ~/ 60Hz electrical outlet with three-prong ground.
The cord should be secured behind the appliance and not left exposed or dangling to prevent accidental
injury.
Do not use an adapter plug with this appliance.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance.
Steps To Replace Water Bottle
? Use a clean cloth to wipe off neck of bottle.
? Remove cap, if there is one on.
? Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
? Wipe off any water, which may have splashed on dispenser top.
Cold Water Control
Turn the switch marked “COLD” ON. The green (COLD) indicator will be lit and the process begins.
When the water reaches the right temperature the green (COLD) indicator goes off automatically.
Hot Water Control
Turn the switch marked “HOT” ON. The red (HOT) indicator will be lit on and the unit will begin to heat
the water. When the water reaches the right temperature the red (HOT) light goes off automatically.
When the temperature goes down to approx. 86º C (187º F), the red indicator will glow again and another
?WARNING?
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF
THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS
SERVICE CENTER.