6
IT WILL TAKE APPROXIMATELY 1 HOUR TO REACH OPTIMUM TEMPERATURE. IF YOU CONSUME ONE 8 OZ.
CUP, THE RECOVERY TIME IS APPROXIMATELY 25 MINUTES OR LESS. IF YOU CONSUME 2 OR MORE 8
OZ
. CUPS, RECOVERY TIME CAN TAKE UP TO 1 HOUR.
o Turn the cold and hot water switches ON (at the rear).
o Now you are ready to use your water dispenser.
NOTE: Your water dispenser has been cleaned and sanitized before leaving the factory, but in
case a taste problem develops, place one tablespoon of baking soda and add tap water. Fill water
tank again and repeat basic operations previously outlined.
OPERATING YOUR WATER DISPENSER
Electrical Connection
This appliance should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the
possibility of electrical shock.
Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
power and/or grounding should be directed toward a certified electrician or an authorized Avanti
Products service center.
This appliance requires a standard 115/120 Volts A.C. ~/ 60Hz electrical outlet with three-prong
ground.
The cord should be secured behind the appliance and not left exposed or dangling to prevent
accidental injury.
Do not use an adapter plug with this appliance.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance.
Steps To Replace Water Bottle
z Use a clean cloth to wipe off neck of bottle.
z Remove cap (if one is present).
z Carefully lift bottle, do not place hands on the opening of the bottle while placing on the water
intake opening.
z Insert the water bottle into the water intake over the reservoir opening so that it settles properly.
z Wipe off any water which may have splashed on dispenser top.
aWARNINGa
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF
THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS
SERVICE CENTER.