Filter
Top Products
9
During “Energy Saver” Program, when you press the “HOT WATER” button, the (red) “HOT” cycle
indicator will be on and water temperature in the reservoir will be heated to 90ºC/194ºF
(approximately 4 minutes). Once the water temperature reaches 90ºC/194ºF the (red) “HOT” cycle
indicator will turn off and will remain off until the “HOT WATER” button in pressed again.
Normal Program:
When the PROGRAM button is released, it’s under Normal operation mode and the (orange) NORM
indicator light will displayed. During operation the (red) “HOT” cycle indicator will be on until the
temperature of the water in the reservoir reaches 90ºC/194ºF (approximately 9 minutes). The (red)
“HOT” cycle indicator will turn off and will remain off until the temperature of the water in the reservoir
drops to 81ºC/178ºF at which time the (red) “HOT” cycle indicator will turn on and the cycle will start
again.
When the unit is in “NORMAL PROGRAM” the “HOT WATER” button is non-functional.
Cold Temp (Energy Saver / Normal Modes):
The cold water cycle is not affected by either program and continuously runs to maintain a cold water
temperature between 5ºC/41ºF and 10ºC/50？ºF. Once the “Cold Switch” at the rear of the unit is
turned ON the (blue) “COLD” cycle indicator will be on until the temperature of the water in the
reservoir drops to 7℃/44ºF or less, the (blue) “COLD” cycle indicator will turn off and the cooling cycle
will stop until the temperature reaches 10/50ºF, at which time the (blue) “COLD” cycle indicator will
turn on again and the cooling cycle will start again.
Light:
When the light button is pushed, the light will turn on. Pushed again, the light will turn off.
To get hot water:
♦ Slide red safety button to the right and hold while pressing downward on hot water faucet to
dispense hot water.
♦ Safety button will return to its original position when faucet is released.
Cup Dispenser
(OPTIONAL)
The cup dispenser may be installed by using the mounting holes (covered with plastic caps) located
near the top of the right side panel of the cooler. The cup dispenser comes equipped with a mounting
bracket and screws and may be ordered by completing the enclosed order form provided with your
instruction manual.
CARE AND MAINTENANCE
• Wash the inside of the reservoir with a warm water and baking soda solution. The solution should
NOTE:
THE HOT WATER FAUCET HAS A CHILD-SAFETY GUARD ATTACHMENT.