USE AND CARE 7
FILLING THE FILTER BOTTLE WITH TAP WATER
1. Remove lid.
2. Slowly ll the upper reservoir with cold tap water. Be careful not to dump
water too quickly into the upper chamber when the lower chamber is
empty because
it may tip and spill.
3. Allow water to pass from the upper chamber through the lters to the
lower chamber. Water will be ready to drink in several minutes.
4. Test the water using the TDS meter to conrm a “000” reading.
5. If it doesn’t read “000”, ush the water out, check all connections and
seals.
6. Pour water through.
7. Do not over ll. The rst time you ll your Filter Bottle it will take extra
water to ll the cooler reservoir. When water in the lower chamber
reaches the line marked “MAXIMUM WATER LEVEL”, do not put any
more water in the upper chamber, as it may leak. The upper chamber is
not designed to be a long term reservoir.
Safety Precautions: Do not use with water that is microbiologically unsafe
or of unknown quality without proper disinfection before or after the
system. Individuals requiring water of specic microbiological purity should
consult their physician. Unless notied otherwise, municipal water is
potable.