Bakers Pride Oven ALF-F Fryer User Manual


 
Automatic Lift Fryer
29
Troubleshooting
Refer to the table below for troubleshooting information.
Problem Cause Possible Solution
Shortening Heating Too
Slowly
Low voltage or improper
voltage
Contact an authorized BKI service
agent for corrective action.
Bad thermostat or loose
wires
Contact an authorized BKI service
agent for corrective action.
Weak heating elements or
heating elements breaking
down
Contact an authorized BKI service
agent for corrective action.
Coil on contactor is bad Contact an authorized BKI service
agent for corrective action.
Breading build-up on heating
elements
Clean heating elements. If problems
persist, contact an authorized BKI
service agent for corrective action.
Filter System Not Working
Uncertain Press the reset button on end of pump
and hi-limit reset button under control
panel. If problems persist, contact an
authorized BKI service agent for
corrective action.
Connections not tight Tighten the connections. If problems
persist, contact an authorized BKI
service agent for corrective action.
Filter valve not open Contact an authorized BKI service
agent for corrective action.
Filter paper on screen
clogged with crumbs
Change filter paper. If problems
persist, contact an authorized BKI
service agent for corrective action.
Motor hums, but does not
pump
Check for clogged pump. If problems
persist, contact an authorized BKI
service agent for corrective action.
Motor and pump coupling
worn
Contact an authorized BKI service
agent for corrective action.
No power to control panel Make sure drain valve is completely
closed. If problems persist, contact an
authorized BKI service agent for
corrective action.
Computer Hangs
Computer malfunction. Press and hold the Toggle/Clear
button while moving the
FRY/OFF/FILTER switch from FRY to
OFF and back to FRY. If problems
persist, contact an authorized BKI
service agent for corrective action.