Filter
Top Products
4
f) Move the oven to its final location (in case of casters, release the brakes, then reapply once in position),
maintaining the minimum distances specified in section 2. Above.
g) Remove all loose parts and packages from the oven interior.
h) Insert the short piece of tapered pipe supplied (see fig. 4) into the hole at the top, located near the left rear
corner of the oven (see fig. 5A). Turn it to the desired direction, mark the location of the holes and drill three
1/8” diameter holes, then secure it with the screws supplied for that purpose. This pipe is to prevent accidental
closure of the vent opening by items stored on top of the oven.
Figure #3
BAKERS
PRIDE
Figure #2
Figure #1
Figure #4
Flue Diverter
Warning Label
Warning
Label
Left Rear Leg
w/Caster &
Restraining Plate
Restraining
Plate