Filter
Top Products
8
D. SERVICING:
NOTE: THIS APPLIANCE MUST BE SERVICED BY AN AUTHORIZED SERVICE AGENT.
(1) Power supply to the unit must be disconnected before any service is performed.
(2) Most of the service on the unit can be performed from the front and/or control panel side.
(3) For proper servicing, access to the control panel side of the unit will be required.
(4) It will be necessary to have access to the back of the oven for service needs related to the
electric power supply.
(5) A system wiring diagram is provided in this manual and on the back of the service panel on the
right side of the oven.
(6) All servicing should be performed by a factory-authorized technician only.
(7) For proper maintenance and repairs, call the factory toll free (800-431-2745) for an authorized
service agency in your area.
Cleaning The Blower Wheel
Figure 1
!
!
CAUTION: This product, when stacked, has more than one power-supply
connection point. Disconnect all power supplies before servicing.
!
!
WARNING: RISK OF FIRE. When stacked two high maximum, use stacking kit
part # E3771A only.
Wheel Puller Bolt 3/8” Hex
Blower Wheel
Set Screw (2)
Motor
Figure 2
OPEN RACK STAND ASSEMBLY INSTRUCTIONS: BCO-E & GDCO-E
Assembly Instruction
1. Place undershelf (6) between legs & secure with
1/4-20 UNC screws (4), flat washers (3) &
locknuts (2). The holes for mounting the wire
racks should be toward the front of the oven.
2. Place open rack supports (1) between legs &
secure with 1/4-20 UNC screws (4), flat washers
(3) & locknuts (2).
3. Slide wire rack supports (5) into position using
the holes in the undershelf (6) as a guide.
1
2
3
4
5
6
Open Style Support Leg Not Supplied With Kit
1 21818232 Support, Open Rack 2
2 770504 Lock Nut 1/4-20 12
3 8519600 Washer, Flat 1/4” 12
4 8208200 Screw, 1/4-20 x 3/4” 12
5 21816807 Support, Wire Rack 2
6 21818220 Undershelf, Gas Oven 1
Item P/N Description Quan