Filter
Top Products
Sandwich/Fry Warmer Installation
9
FW-15L
1. Obtain a suitable countertop location for the unit that will provide a clearance of 4” from the side louvers.
2. Cut a hole in the countertop to fit the collar weldment according to the drawing below.
3. Using a 2” hole saw, drill a hole in the countertop (under where the louvered blower box will be
positioned) for the power cord to pass through.
4. Position collar weldment into the cutout area with slotted holes toward the main unit.
5. Position the main unit as shown above ensuring that the side panel flanges are under the flanges of the
collar weldment.
6. Line up the back attachment holes on the flanges of the main unit with the slotted holes in the flanges of
the collar weldment.
7. Remove the louvered blower box to access the front attachment holes by unscrewing 7 screws shown
below.