Filter
Top Products
10 / 27 EN
Refrigerator / User Manual
4 Preparation
4.1. Things to be done
for energy saving
A
Connecting the product to electric energy
saving systems is risky as it may restrict
operation of the product.
• Do not leave the doors of your refrigerator
open for a long time.
• Do not put hot food or drinks in your
refrigerator.
• Do not overload the refrigerator. Cooling
capacity will fall when the air circulation inside
is hindered.
• Do not place the refrigerator in places subject
to direct sunlight. Install the product at least
30 cm away from heat sources such as hobs,
ovens, heaters and stoves.
• Store your food in refrigerator in closed
containers.
• Thawing frozen food in fridge compartment
will both provide energy saving and preserve
the food quality.
C
The ambient temperature of the room
where you install the refrigerator
should at least be 5°C. Operating your
refrigerator under cooler conditions than
this is not recommended.
C
Inside of your refrigerator must be
cleaned.
C
If two coolers are to be installed side
by side, there should be at least 4 cm
distance between them.
4.2. Efficient operation
Specified energy consumption value of your
refrigerator is determined under maximum load by
removing the freezer compartment upper rack and
while other racks and two bottom drawers are in
place. There is no harm to remove a shelf or drawer
to accommodate the shapes and size of food to be
frozen.
4.3. Recommendations on
the fridge compartment
• Do not allow the food to touch the
temperature sensor in fridge compartment.
To allow the fridge compartment to keep its
ideal storage temperature, sensor must not
be hindered by food.
• Do not put hot food and beverages inside the
product.
4.4. Initial use
Before starting to use the product, check that all
preparations are made in accordance with the
instructions in sections "Important instructions
for safety and environment" and "Installation".
• Clean the interior of the refrigerator as
recommended in the “Maintenance and
cleaning” section. Check that inside of it is
dry before operating it.
• Plug the refrigerator into the grounded wall
outlet. When the door is opened the interior
illumination will turn on.