Beko CDA 565FW Refrigerator User Manual


 
EN
7
3 Installation
TRANSPORTATION
INSTRUCTIONS
1.The appliance should be transported
only in a vertical upright position. The
packing as supplied must be intact
during transportation.
2.If during the course of transport
the appliance has to be transported
horizontally, it must only be laid on its
right hand side when standing in the
front of the appliance. After bringing
it to upright position,it must not be
operated for at least 4 hours to allow
the system to settle.
3.Failure to comply with the
above instructions could result in
damage occuringto the appliance.
The manufacturer will not be held
responsible if these instructions are
disregarded.
4.The appliance must be protected
against rain, moisture and other
atmospheric influences.
5.When positioning your appliance
take care not to damage your flooring,
pipes, wall coverings etc. Do not move
the appliance by pulling by the door or
handle.
6. Empty any water in the drain
tray before moving. See section
‘Defrosting’ and ‘Care & cleaning’ for
further information.
7. Make sure that the defrost water
pipe at the back of the product is fixed
to the plastic evaporating pan on the
top of the compressor, to avoid defrost
water spillage on the floor.
IMPORTANT : Care must be taken
while cleaning / carrying the appliance
to avoid touching the bottom of the
condenser metal wires at the back of
the appliance as you might injure your
fingers and hands.
Do not attempt to sit or stand on top
of your appliance as it is not designed
for such use. You could injure yourself
or damage the appliance.
“IMPORTANT: Make sure that
mains cable is not caught under the
appliance during and after carrying
/ moving the appliance, to avoid
the mains cable becoming cut or
damaged.”
Do not allow children to play with
the appliance or tamper with the
controls. BEKO declines to accept any
liability should the instructions not be
followed.
IMPORTANT
INSTALLATION
INSTRUCTIONS
1. The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
2. This appliance has been designed
to operate in ambient temperatures up
to 32 degrees C (90 degrees F) and
is equipped with Advanced Electronic
Temperature Control System [AETCS]
which ensures that at the advised
setting [4 - four on the knob] the frozen
food in the freezer will not defrost
even if the ambient temperature falls
as low as -15 °C. When first installed
the product MUST NOT be placed in
low ambient temperatures because
the freezer will not reduce to it’s
standard operating temperature. Once