EN
7
3 Installation
Transportation Instructions
1.The appliance should be transported
only in a vertical upright position. The
packing as supplied must be intact
during transportation.
2.If during the course of
transport the appliance has to be
transported horizontally, it must
only be laid on its right hand side
when standing in the front of the
appliance. After bringing it to
upright position,it must not be
operated for at least 4 hours to
allow the system to settle.
3.Failure to comply with the
above instructions could result in
damage occuring to the appliance.
The manufacturer will not be held
responsible if these instructions are
disregarded.
4.The appliance must be protected
against rain, moisture and other
atmospheric influences.
5.When positioning your appliance
take care not to damage your flooring,
pipes, wall coverings etc. Do not move
the appliance by pulling by the door or
handle.
6. Empty any water in the drain tray
before moving. See section ‘Defrosting’
and ‘Care & cleaning’ for further
information.
7. Make sure that the defrost water
pipe at the back of the product is fixed
to the plastic evaporating pan on the
top of the compressor, to avoid defrost
water spillage on the floor.
IMPORTANT : Care must be taken
while cleaning / carrying the appliance
to avoid touching the bottom of the
condenser metal wires at the back of
the appliance as you might injure your
fingers and hands.
Do not attempt to sit or stand on top
of your appliance as it is not designed
for such use. You could injure yourself
or damage the appliance.
“IMPORTANT: Make sure that mains
cable is not caught under the appliance
during and after carrying / moving the
appliance, to avoid the mains cable
becoming cut or damaged.”
“IMPORTANT: This appliance is
not designed for stacking with any
other appliance.When positioning your
appliance, take care not to damage
your flooring, pipes,wall coverings etc.
Do not allow children to play with the
appliance or tamper with the controls.
BEKO declines to accept any liability
should the instructions not be followed.
Important
Installation Instructions
1. The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
2. This appliance has been designed to
operate in ambient temperatures up
to 32 degrees C (90 degrees F) and is
equipped with ‘Freezer Guard’ which
ensures that at the advised setting [4
- four on the control] the frozen food
in the freezer will not defrost even if
the ambient temperature falls as low
as -15 °C. So you may then install
your appliance in a garage or an