Beko CFD 6913 APX Freezer User Manual


 
EN
10
3. Do not place the appliance near
cookers, radiators or in direct sunlight
as this will cause your appliance to
work harder. If installed next to a
source of heat or freezer, maintain the
following minimum side clearances:
From Cookers 50 mm (2”)
From Radiators 300 mm (12”)
From Freezers 25 mm (1”)
4. Make sure that sufficient room
is provided around the appliance to
ensure free air circulation. Fit the two
plastic wall spacers supplied with the
appliance to the condenser on the
back of the appliance by rotating 1/4
turn.
(See Diagram)
5. The fridge/freezer should be
located on a smooth surface. The
two front feet can be adjusted as
required. To ensure that your appliance
is standing upright adjust the two
front feet by turning clockwise or
anti-clockwise, until the product is
in firm contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.
6. Refer to cleaning and care section
to prepare your appliance for use.
7. A special receptacle is supplied
to store the mains plug during transit.
The receptacle is fixed at the back
of the cabinet, on the side of the
compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage.