Beko CWB9403X Ventilation Hood User Manual


 
10 / 11 EN
4 Use and Maintenance
4.2 Replacing halogen light bulbs
(Fig.8):
To replace the halogen light bulbs B, remove the
glass pane C using a lever action on the relevant
cracks. Replace the bulbs with new ones of the
same type. Caution: do not touch the light bulb with
bare hands.
Fig.8
Fig.9
• Commands (Fig.10) mechanical the key symbols
are explained below:
A = LIGHT
B = OFF
C = SPEED I
D = SPEED II
E = SPEED III.
Fig.10
If your appliance has the INTENSIVE speed function,
from speed THREE, press key E for 2 seconds and
it will be activated for 10 minutes after which it will
return to the previously set speed. When the func-
tion is active the LED flashes.
To interrupt it before the 10 minutes have elapsed,
press key E again. Some models allow activating
this function even with speed one and two.
By pressing key F for two seconds (with the hood
switched off) the “clean air” function is activated.
This function switches the appliance on for ten min-
utes every hour at the first speed. As soon as this
function is activated the motor starts up at the first
speed for ten minutes. During this time key F and
key C must flash at the same time. After ten minutes
the motor switches off and the LED of key F remains
switched on with a fixed light until the motor starts
up again at the first speed after fifty minutes and
keys F and C start to flash again for ten minutes
and so on. By pressing any key for the exclusion
of the hood light the hood will return immediately
to its normal functioning (e.g. if key D is pressed
the “clean air” function is deactivated and the motor
moves to the 2nd speed straight away. By pressing
key B the function is deactivated).
Hood / User Manual