Filter
Top Products
EN
19
Safety lock for Water Dispenser
You may use the lock in order to avoid
small children tampering with the water
dispenser. To do this, slide the locking
latch from left to right as illustrated in
the figure. You must slide the latch
back to left position in order to use the
water dispenser.
To avoid accidental water dispensing,
we recommend you to lock the water
dispenser.
UNLOCK LOCK
Remove the plastic drainer part as
shown in the diagram by pressing
down on the edge.
Remove the water valve from the water
tank as shown in the diagram. When
re-fitting, make sure the O-shaped seal
is in place.
Maximum height of glass suitable
for use with Stored Water Dispenser
is 16 cm which includes most of the
“Standard” pint glasses.
• Only use clean pure drinking water.
• Capacity of water dispenser tank is 2.2
litres [3.8 pints], do not overfill.
• Push the water dispenser lever with
a rigid cup. If you are using a plastic
disposable cup, then push the lever
with your fingers from behind the cup.
Cleaning the water tank
Remove the water tank, open the
latches on both sides and detach the
top cover mechanism from the water
tank. Clean the water tank with warm
clean water, reinstall the top cover
mechanism and fasten the latches.
When installing the water tank, make
sure that hooks behind it fits securely
into the hangers on the door. Make
sure that parts removed during
cleaning (if any) are installed correctly
into their original locations. Otherwise,
water may leak.
Important:
Water tank and components of water
dispenser are not dishwasher-proof.
Water tray
Water that drips while using the water
dispenser accumulates in the drip
tray. Remove the drip tray by pulling
it towards yourself and empty it from
time to time.