16
GB
aid in the rinse aid dispenser of your
machine.
You can adjust the amount of rinse
aid used during the wash programme
by turning the rinse aid dispenser
regulator (C).
The dispenser regulator (C) may be set
between levels 1 and 6 (6 being the
maximum amount of rinse aid usage).
Your machine is pre-set at the factory
to level 4.
According to the finish and drying
results obtained, adjust the dose of
rinse aid by means of the six position
selector. (Position 1: minimum dose,
Position 6: maximum dose.) Gradually
increase the dose if there are drops of
water or lime spots on the dishes after
washing. Reduce it if there are sticky
whitish streaks on the dishes.
Filling the rinse aid dispenser
Open the rinse aid dispenser lid by
pressing the button as shown in the
diagram.
Fill up with rinse aid until the container
is full to level of ’max’ mark .
Put the lid (E) on and ensure you hear
the clicking sound.
Remember to CLOSE the lid after
every refill.
Make sure you clean any rinse aid that
you might have spilled.
Powder and gel detergents are poured
into the dispenser.
If you are using tablet detergent read
the manufacturer’s recommendations
on the packaging in order to determine
where the tablets should be placed
inside the dishwasher (detergent
dispenser, cutlery basket, etc.)
After you put in the detergent, shut the
container lid (D) and ensure you hear
the clicking sound.
During the wash programme the
detergent will dispense automatically
and the lid (D) will remain open when
the programme finishes.
Detergent residues
Regular use of low temperature
washes and/or short duration
programmes can lead to undissolved
detergent residue build up. We
recommend to carry out a service wash
at the highest temperature possible
every 3 - 4 months with the dishwasher
empty and without using detergent.
Rinse aid
Use only rinse aid intended for
household dishwashers.
The rinse aid is specially formulated
to be used in the dishwashers for the
prevention of watermarks and scale on
dishes and to increase the efficiency
of the washing and drying processes.
Therefore, make sure that
there is adequate amount of rinse