Filter
Top Products
2
CONTENTS
PAGE
SAFETY FIRST / ELECTRICAL REQUIREMENTS
TRANSPORTATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
REPOSITIONING THE DOOR
SUGGESTED ARRANGEMENT OF FOOD IN THE FRIDGE
TEMPERATURE CONTROL AND ADJUSTMENT
STARTING
STORING FROZEN FOOD
MAKING ICE CUBES
DEFROSTING
CLEANING AND CARE
REPLACING THE INTERIOR LIGHT BULB
DO'S AND DON'TS
PROBLEM SOLVING/TROUBLE SHOOTING
GUARANTEE DETAILS
HOW TO OBTAIN SERVICE
3
4
5
6-7
8
9
10
10
10
11
12
13
13-14
14
15
16
3
GREEN &
YELLOW
OR
GREEN
N
BLUE
OR
BLACK
L
BROWN
OR
RED
22 mm.
6 mm.
CORD GRIP
6 mm.
6 mm.
32 mm.
12 mm.
FITTED WITH
BS 1362 13A FUSE ALWAYS
FIT BS 1362 REPLACEMENT
CARTRIDGE FUSE
FUSE
IMPORTANT! FITTING A DIFFERENT PLUG
As the colours of the wires in the
mains lead of this appliance may
not correspond with the coloured
markings identifying the terminals
in your plug proceed as follows:
(See diagram).
1. Connect the green-yellow or
green (Earth) wire to the terminal
in the plug marked 'E' or with
the symbol or coloured
green and yellow or green.
2. Connect the blue (Neutral) wire
to the terminal in the plug
marked 'N' or coloured black.
3. Connect the brown (Live) wire to
the terminal in the plug marked 'L'
or coloured red.
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or
in the main fuse box.
If in doubt contact a qualified electrician.
FREEZING FRESH FOOD
10
ELECTRICAL REQUIREMENTS
Before you insert the plug into the wall socket make sure that the voltage and the frequency
shown in the rating plate inside the appliance corresponds to your electricity supply. Rating
label is on the left hand side of fridge liner.We recommend that this appliance is connected
to the mains supply via a suitable switched and fused socket in a readily accessible position.
Should the mains lead of the appliance become damaged or should it need replacing at
any time, it must be replaced by a special purpose made mains lead which can only be
obtained from a BEKO Authorised Service Agent.
WARNING!
THIS APPLIANCE MUST BE EARTHED
If the fitted moulded plug is not suitable for your socket, then the plug should be cut off
and an appropriate plug fitted. Destroy the old plug which is cut off as a plug with bared
cord could cause a shock hazard if inserted into a socket elsewhere in the house.The
moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be
replaced an ASTABEAB approved BS 1362 fuse of the same rating must be used. Do not
forget to refit the fuse cover. In the event of losing the fuse cover the plug must not be used
until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must
be the same colour as that visible on the pin face of the plug. Fuse covers can be obtained
from a BEKO authorised service agent.