Filter
Top Products
EN
7
3 Installation
TRANSPORTATION
INSTRUCTIONS
1. The appliance should be
transported only in a vertical
upright position. The packing as
supplied must be intact during
transportation.
2. If during the course of transport
the appliance has to be
transported horizontally, the
product must only be laid on its
right hand side (when facing the
door front) and it must not be
operated for at least 4 hours to
allow the system to settle after
the appliance is brought back to
upright position.
3. Failure to comply with the
instructions could result in damage
occurring to the appliance. The
manufacturer will not be held
responsible if these instructions are
disregarded.
4. The appliance must be protected
against rain, moisture and other
atmospheric influences.
5. When positioning your appliance
take care not to damage your
flooring, pipes, wall coverings etc.
Do not move the appliance by
pulling by the door or handle.
6. Empty any water in the drain tray
and Water Dispenser tank before
moving. See section ‘Defrosting’
and ‘Care & cleaning’ for further
information.
7. Make sure that the defrost water
pipe at the back of the product is
fixed to the plastic evaporating pan
on the top of the compressor, to
avoid defrost water spillage on the
floor.
Important Care must be taken
when carrying the appliance to avoid
touching the bottom of the condenser
metal support/pipework at the back of
the appliance as you might injure your
fingers and hands or damage your
product.
Important Make sure that mains cable
is not caught under the appliance
during and after carrying/moving the
appliance, to avoid the mains cable
becoming cut or damaged.
Do not attempt to sit or stand on top
of your appliance. You could injure
yourself and damage the appliance.
BEKO plc declines to accept any
liability should the instructions not be
followed.
Installation Instructions
1. Fit the two plastic wall spacers
supplied with the appliance onto the
condenser at the back of the appliance
by rotating 1/4 turn.
2. Locate the appliance on a smooth
surface.
3. To ensure it is standing upright
adjust the two front feet by turning
clockwise or anti-clockwise, until it is