Filter
Top Products
6
IMPORTANT
INSTALLATION INSTRUCTIONS
1. The space in the room where the appliance is installed must not be smaller
than 10 cubic metres.
2. If possible avoid placing the appliance near cookers, radiators or in direct
sunlight as this will cause the compressor to run for long periods. If installed
next to a source of heat or refrigerator, maintain the following minimum side
clearances:
From Cookers 2" (50 mm)
From Radiators 12" (300 mm)
From Refrigerators or Freezers 1" (25 mm)
Allow a minimum of 60 mm (2.4 inches) between the top of the fridge and the
ceiling or the underside of a wall cupboard.
3. Make sure that sufficient room is provided around the appliance to ensure free
air circulation.
4. Fit the two plastic wall spacers supplied
with the appliance rotating 1/4 turn to
the condenser at the back of the
refrigerator (see diagram).
5. The appliance should be located on a
smooth surface. The two front feet can be
adjusted as required. To ensure that
your appliance is standing upright adjust
the two front feet by turning clockwise or anti-clockwise, until the product is in
firm contact with the floor. Correct adjustment of feet avoids excessive
vibration and noise.
6. Refer to "Cleaning and Care" section to prepare your appliance for use.
7. This appliance has been designed to operate in ambient temperatures
beetween +10 and +32 degrees C (50 and 90 degrees F).Therefore if the
appliance is installed in an unheated / cold room (E.g.: Conservatory /
annex / shed / garage etc.) then the food in the larder fridge [In particular
salad, fruit, water and fruit juices] will start freezing because of the cold ambient
temperature when the temperature drops below 0 C [Zero degrees Centigrade].
The appliance will resume normal operation when the ambient temperature rises
back above +5 C. Please note, between 0 C and +5 C, the compressor will not
run but the temperature in the larder fridge will be safe to store your food
anyway. So don't worry when the compressor does not operate between 0 C
and +5 C.
8. A special receptacle is supplied to store the mains plug during transit.
The receptacle is fixed at the back of the
cabinet, on the right hand side of the
compressor. (See diagram) Gently remove
the plug from the receptacle. Never pull
the mains cord, you may damage the
appliance. In the case of transportation,
ensure you locate the plug in the receptacle
provided to avoid transit damage.
7
GETTING TO KNOW YOUR LARDER FRIDGE
Arrangement Examples (See diagram).
8
7
4
2
*6
5
1
3
3
3
3
3
9
10
11
9
9
11
9
Interior light
Thermostat knob
Movable shelves
Defrost water collection channel - Drain tube
Crisper cover
Chiller drawer with humidity control
Crisper
Adjustable front feet
Adjustable door shelves
Egg compartment
Bottle shelf
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.