Filter
Top Products
IMPORTANT
INSTALLATION INSTRUCTIONS
1. The space in the room where the appliance is installed must not be smaller
than 10 cubic metres.
2. If possible avoid placing the appliance near cookers, radiators or in direct
sunlight as this will cause the compressor to run for long periods. If installed
next to a source of heat or refrigerator, maintain the following minimum side
clearances:
From Cookers 2" (50 mm)
From Radiators 12" (300 mm)
From Refrigerators or Larder Fridge 1" (25 mm)
3. Make sure that sufficient room is provided around the appliance to ensure free
air circulation. Allow a minimum of 60 mm (2.4 inches) between the top of the
fridge and the ceiling or the underside of a wall cupboard.
4. Fit the two plastic wall spacers supplied with the appliance rotating 1/4 turn
to the condenser at the back of the appliance (See diagram).
5. The appliance should be located on a smooth surface.
The two front feet can be adjusted as required.
To ensure that,your appliance is standing
upright adjust the two front feet by turning
clockwise or anti-clockwise, until the product
is in firm contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.
6. Refer to "Cleaning and Care" section to
prepare your appliance for use.
6
5
A special receptacle is supplied to store the
mains plug during transit.
The receptacle is fixed at the back of the
cabinet, on the right hand side of the
compressor. (See diagram) Gently remove
the plug from the receptacle. Never pull
the mains cord, you may damage the
appliance. In the case of transportation,
ensure you locate the plug in the receptacle
provided to avoid transit damage.
7.
INDICATOR LIGHTS
There are three coloured indicator lights located on the front of the appliance
which shows the operating mode of the freezer.
Indicator lights slightly flicker. This is by design and not a fault, don’t worry. This
low energy consumption design is developed to achieve the lowest possible electiricty
use.
Green Indicator (1)
Illuminates when the appliance is connected to the mains and will glow as long as
electricity is available. The green indicator does not give any indication of the
temperature inside the freezer.
Amber Indicator (2)
This indicator will glow when the fast freeze button (4) is on and will continue to
glow for 34 hours until the fast freeze button is turned off. It will automatically turn
off after 34 hours otherwise, the compressor will run continuously while fast freeze
button is on. Fast freeze operation is for freezing fresh food (See Freezing Fresh
Food, page 9).
Red Indicator (3)
Red indicator light has a built-in delay. Once switching on, it will not come on for
24 hours.
This indicator will glow when the internal temperature rises above -5°C and it will
automatically de-activate when the internal temperature falls below -9°C
Thermostat Knob (5)
Thermostat knob is located on the indicator light set.
Temperature Display (6)
Display shows actual internal temperature. When you switch on fast frezee, it will
display - 27 °C for 5 seconds. When you rotate the knob, it displays the new setting
for 5 seconds and then reverts back to actual temperature.
IMPORTANT :
When you press the fast freeze button (4), there may be a short delay before the
compressor starts to operate. This is normal and not a compressor fault, don’t worry.
- E0 flashes on display (6) if there is a freezer sensor failure.
- E1 flashes on display (6) if there is a defrost sensor failure.
- E4 blinks on display if there is a heater failure.
4 5 6 2 1 3
Electronic card
(covered by plastic cover)