Filter
Top Products
Step 1: Prepare installation
Do not lift the appliance by the
door handle.
Remove the fixing screws from the
polythene bag on the top of the
appliance, but leave the appliance in
the base tray packaging until you are
ready to install it.
Whilst every care is taken to eliminate
burrs and raw edges from this appliance,
please take care when handling - we
recommend the use of protective
gloves during installation.
Please note that the weight of this
appliance is approximately 48kg
(unpacked). Take care when lifting it
into the housing unit - always use an
appropriate method of lifting.
Note: When removing the appliance
from the base tray packaging care
should be taken to ensure the appliance
is not damaged.
Siting the appliance
If this appliance is to be installed near
to a corner where the adjacent
cabinets run at right angles forward of
the appliance, there must be a gap of
at least 90mm between the appliance
and the cabinets, to prevent
overheating of the cabinets.
When installed in a typical 600mm
deep built in housing unit, the false
back should be removed from the
housing unit, to provide the necessary
depth for installation.
When the false back is removed, it is
normally the case that the support shelf
for the appliance leaves a gap
between the back edge of the support
shelf and the rear wall of
approximately 80mm.
If no gap occurs between the back
edge of the shelf and the wall behind
the unit, you must create a gap of at
least 30mm by shortening the shelf
and any other shelf below the appliance.
Cut 12mm from the top of any plinth
that may be fitted (see diagram).
Important: Do not modify the outer
panels of this appliance in any way.
25
INSTALLATION INSTRUCTIONS