Filter
Top Products
6
• Installation Instructions
• Wall fitting
The cooker hood may be fitted to any rigid vertical surface. All the fittings supplied are
to be found in the polythene bag.
Important: Before installation, check the wall to which the cooker hood is to be fitted, for
electric cables, water or gas pipes before drilling. If it is necessary to fix the hood to a
hollow construction, plaster or partition structure, suitable fittings (not included) must be
used.
• Mounting the hood to the wall
Drill 8 holes (B, C, D) respecting the distances indicated (Fig. 3) and the holes A using
the bracket Z as template. Fix the bracket Z to the wall (Fig. 3).
Hang the hood on the wall using the holes C (Fig. 3). After having levelled the appliance
finally secure the hood to the wall using the holes D.
• Internal Exhausting
Screw the connecting flange Y to the exhaust fan unit on the hood body (Fig. 2). Insert the
upper flue E into the lower flue F with the slots facing upwards. Pull out the upper flue as
far as the bracket Z and fix it with the screws provided.
Charcoal filters are used to purify the air which will be recycled into the room. The filters
cannot be washed or regenerated and must be replaced every 4 months.
The charcoal filters are supplied as an optional extra, please phone Belling Spares
department on 0
844 815 3745 and quote part number CHT28.
Saturation of the activated charcoal depends on more or less extensive use of the hood,
the type of kitchen and the regularity of cleaning the grease filter. The air is recycled into
the room through the slots in the flue E.
• External Exhausting
Fix the connecting flange Y (Fig. 2). By means of a connection pipe of 120 mm internal
diameter, connect the flange Y to the outlet opening. Insert the upper flue E into the lower
flue F with the slots facing downwards (Fig. 2).
Fix the lower flue to the wall using the previously drilled holes B (Fig. 3). Pull out the
upper flue as far as the bracket Z and fix it with the screws provided.
• Electrical Connection
Before connecting to the mains supply ensure that the voltage is as stated on the rating
plate inside the cooker hood.
Warning: This appliance is fully insulated and must not be earthed.
The appliance comes with a 2 core mains cable and should be permanently connected to
the electricity supply via a double pole switched fused spur outlet with a minimum contact
clearance of 3mm in both poles.
Installation must comply with the latest IEE regulations and must be carried out by a
competent person.
The cooker hood must be protected by a 3-amp fuse.