Filter
Top Products
Belshaw Bros., Inc. 1750 22
nd
Ave. S. Seattle, WA 98144 Phone 206-322-5474 Fax 206-322-
5425
BX Classic Oven MN-1876EN 3
Programming the control
panel
Pre-set values for bake temperatures, bake time,
steam and damper may be modified at any time.
Numbers in parentheses reference numbers in Figure
1-2.
To change the program values:
1. Press the up and down arrow keys (2) to select the
program you wish to change.
2. Press the key next to the value you wish to change
(i.e. temperature or time) (6-9). A selection
indicator will flash in the right hand side of the
selected window. Use the up/down arrow keys to
modify the value.
3. The program can be run using these values as a
temporary setting, or the setting changes can be
saved. If the program changes are not saved, the
settings will revert back to the original settings the
next time the program is selected.
4. To save the changes, press and hold the P key (5).
All displayed values will flash and the controller
will beep to indicate the program has been saved.
After the controller has beeped, release the P key.
Note: Programs cannot be saved during a bake
cycle.
Function of Setting
Key 6: Vent Time. This is the number of minutes at
which the vent will wait to open during the
bake cycle.
Note: This time cannot exceed the bake time.
Key 7: Steam Time. This is the amount of time the
steam will inject at the beginning of the bake.
Time can be set from 1-15 seconds.
Note: The oven must be above 257 F (125 C)
before the steam will inject.
Key 8: Bake Time. This is the amount of time the
product will bake. Time can be set from 1-99
minutes.
Key 9: Temperature. This is the
temperature at which the oven will
bake the product. Temperature can
be set from 122 F to 482 F (50 C
to 250 C).
Fan Cycle Setting
1. Press the P key (5) and the Stop key (4)
at the same time, and hold for five
seconds. The display will show “FAN
00” if the fan is currently disabled or
“FAN 01” if the fan is currently enabled.
2. Use the up/down arrow keys to select
the fan setting.
Note: The default setting for the fan is
"fan cycling disabled."
Note: In a 4-tray oven, the fan is only
functional in an oven wired for 3-phase.
If activated in a 1-phase oven, the fan will
automatically stop.