Filter
Top Products
– 4 –
FMS30 & FMS40 Owner/Operator Manual
ELECTRICAL CONNECTIONS
ELECTRICAL CONNECTIONS (CORD CONNECTED MIXERS)
Single-Phase Mixer
The electrical cord on this machine is equipped with a three-pronged grounding
plug which must be connected to a properly grounded receptacle. If the receptacle is not the
proper grounding type, contact an electrician. Do not remove the grounding prong from the
plug.
ELECTRICAL CONNECTIONS (NON-CORD CONNECTED MIXERS)
Electrical and grounding connections must comply with the applicable portion of
the National Electrical Code and/or other Local Electrical Codes.
Disconnect the electrical power to the machine and follow lockout / tagout
procedures.
Three-Phase Mixer
A hole for the 3/4 "-trade-size conduit is located in the rear of the pedestal. Make electrical connections
per the wiring diagram located on the inside of the top cover.
• Remove side cover.
• Connect fi eld supply lead wires L1, L2, and L3 to supply harness wires labeled "SERVL1",
"SERVL2", and "SERVL3" respectively.
• Connect ground wire to supply harness green wire.
• Reinstall side cover.