Filter
Top Products
– 7 –
FMS10 & FMS20 Owner/Operator Manual
BOWL GUARD / WIRE CAGE
Wire cage must be in position and closed in order to mix. If wire cage is opened during the mixing, mixer
will stop
.
ATTACHMENTS (OPTIONAL FEATURE FOR 20 QUART MIXER)
To install an attachment, loosen the thumb screw on the attachment hub (Fig.1A, page 4) and remove the
plug. Insert the attachment into the attachment hub making certain that the square shank of the attachment
is in the square driver of the mixer. Secure the attachment by tightening the thumb screw.
Close wire cage/bowl guard and raise bowl support to mix position, move the speed select knob to the
desired speed and start the mixer to operate the attachment.
REMOVE BOWL GUARD / WIRE CAGE
Lower the bowl support and remove agitator before removing wire cage. Hold wire cage with both hands
and pull downward gently to release from retainer (Fig. 5).
INSTALL BOWL GUARD / WIRE CAGE
Hold wire cage with both hands and gently push upward until wire cage is latched on the retainer and can
be rotated freely (Fig. 5).
CLEANING
Unplug machine power cord before beginning any cleaning procedures.
The mixer should be thoroughly cleaned daily.
Bowls and agitators should be removed from the mixer and cleaned in a sink.
DO NOT use a hose to clean the mixer — it should be washed with a clean damp cloth.
Clean the Wire Cage/bowl guard by wiping with a cloth or sponge and warm soapy water.
Fig. 5