Filter
Top Products
T +(%$6,&6
The models PM10 and PM20 planetary mixers are designed for mixing doughs, cremes, pota-
toes, mixes, sauces and toppings. They have bowl guards, no-volt release and 3 fixed speeds. In
addition, the PM20 has a 15-minute timer. The PM20 comes equipped with a #12 taper hub for
accepting any #12 attachment, while the PM10 has a #8 taper hub, for accepting any #8 attachment.
On the PM20, the optional VSPH can be used for slicing shredding and grating, while the FCMC can
be used for chopping and grinding.
REVIEW THIS MANUAL COMPLETELY BEFORE USING YOUR MIXER.
I167$//$7,21
SAFE OPERATION REQUIRES PROPER
INSTALLATION AND AN ADEQUATE WORK AREA.
*HQHUDO
1. Berkel suggests having an Authorized Berkel Service Technician install your mixer. A list of
Designated Berkel Service Locations (DBSL) can be found at www.berkel.com. This technician
will demonstrate the operation of the mixer.
2. On the PM20, loosen and remove the 4 lag bolts holding the mixer to the shipping skid. On the
PM10, simply open the box, remove the Styrofoam and lift the mixer out of the box.
3. Install the mixer in a well-lighted area with adequate, unobstructed space so the operator can
move about freely. This location must also be solid and level.
4. For 110-volt mixers, plug into a grounded wall outlet. Never by-pass the mixer’s electrical
switches or circuits. Never activate the mixer using a wall switch. A licensed electrician, ac-
cording to local codes, should wire 220-volt mixers.
WARNING
To prevent the possibility of electrical shock, the mixer must be grounded.
5. Before attaching any accessories/attachments to the mixer, refer to the operating instructions on
page 6 and turn on the mixer in low speed. Check that the rotation of the planetary matches the
sticker on the front of the mixer. If the rotation does not match the sticker, then turn off immedi-
ately and contact a qualified electrician to check the wiring. The direction must match the label.
Make sure the mixer is running smoothly with no obstruction.
PM10 & PM20
OWNER/OPERATOR MANUAL •
5