Filter
Top Products
T +(%$6,&6
The models PM30 and PM40 planetary mixers are designed for mixing doughs, cremes, potatoes,
mixes, sauces and toppings. They have bowl guards, no-volt release, 15-minute timers and 3 fixed
speeds. They come equipped with a #12 taper hub for accepting any #12 attachment. The optional
VSPH can be used for slicing shredding and grating, while the FCMC can be used for chopping and
grinding.
REVIEW THIS MANUAL COMPLETELY BEFORE USING YOUR MIXER.
I167$//$7,21
SAFE OPERATION REQUIRES PROPER
INSTALLATION AND AN ADEQUATE WORK AREA.
*HQHUDO
1. Berkel suggests having an Authorized Berkel Service Technician install your mixer. A list of
Designated Berkel Service Locations (DBSL) can be found at www.berkel.com. This technician
will demonstrate the operation of the mixer.
2. Remove the wooden crating from around the mixer. Loosen and remove the 4 lag bolts (18mm)
holding the mixer to the shipping skid.
3. Install the mixer in a well-lighted area with adequate, unobstructed space so the operator can
move about freely. This location must also be solid and level.
4. For 110-volt mixers, plug into a grounded wall outlet. Never by-pass the mixer’s electrical
switches or circuits. Never activate the mixer using a wall switch. A licensed electrician, ac-
cording to local codes, should wire 220-volt mixers.
WARNING
To prevent the possibility of electrical shock, the mixer must be grounded.
5. Before attaching any accessories/attachments to the mixer, refer to the operating instructions on
page 6 and turn on the mixer in low speed. Check that the rotation of the planetary matches the
sticker on the front of the mixer. If the rotation does not match the sticker, then turn off immedi-
ately and contact a qualified electrician to check the wiring. The direction must match the label.
Make sure the mixer is running smoothly with no obstruction.
PM30 & PM40
OWNER/OPERATOR MANUAL •
5