Filter
Top Products
• Turn the timer to “hold” position, shift to the desired speed and then move the start toggle button.
• Transmission adjustment may be necessary. Contact your nearest Designated Berkel Service
Location.
Overload circuit breaker tripped
• Mixer is overloaded causing the circuit breaker to trip. See the Product Capacity Chart on page
13.
Mixer slips out of gear under load
• Make sure the shift lever is adequately engaged.
• If mixer shift lever is adequately engaged and slipping still exists, then contact your nearest
Designated Berkel Service Location
Product not being properly mixed at the bottom of the bowl
• Inadequate water to product ratio (AR)
• Excessive clearance at the bottom of the bowl and attachment. Contact your nearest Designated
Berkel Service Location.
R(3$,53$5765(3$,56(59,&(
Please contact your nearest Designated Berkel Service Location for any repair parts and/or repair
service required on your Berkel slicer. A list of DBSL’s can be found on the website at
www.berkel.com. Pull down the service tab and then click on your start for the nearest DBSL.
Additional information may be obtained from:
Technical Service Support Center
Berkel Company
4406 Technology Drive
South Bend, IN 46628-9700
(574) 232-8222
(800) 348-0251
PM30 & PM40
OWNER/OPERATOR MANUAL •
11