Filter
Top Products
11
INSTALLATION INSTRUCTIONS
INSTALLER: PLEASE LEAVE THESE INSTRUCTIONS WITH THE OWNER.
Electrical connection CAUTION: Before installing the oven, disconnect the power supply by either
removing the fuse, shutting off the power main or manually tripping the
circuit breaker.
Installation work and repairs should only be performed by a qualified
technician in accordance with all applicable codes and standards. Repairs
and service by unqualified persons could be dangerous and may void the
warranty. The manufacturer is not liable for personal injury, product or
property damage caused by serviced performed by unqualified persons.
Before connecting the appliance to the power supply, make sure that the
voltage and frequency listed on the data plate correspond with the
household electrical supply. This data must correspond to prevent damage
to the product. Consult an electrician if in doubt.
Only operate the appliance after it has been installed in a cabinet.
Power supply The oven is equipped with a 4 ft. (1.2 m.) flexible metal cable with 4 wires
ready for connection to a dedicated 3 pole, 4 wire grounded power supply:
120/240Vac: 5500 Watt or 24 A max.
or
120/208Vac: 4400 Watt or 21 A max.
Black wire
: connect to L1 (hot)
Red wire
: connect to L2 (hot)
White wire
: connect to N (neutral)
Green wire
: connect to GND (ground)
A dedicated line and junction box should be used to connect the oven to a
30 A circuit.
CARING FOR THE ENVIRONMENT
Disposal of packing materials The cardboard box and packing materials protect the appliance during
shipping. Ensure that any plastic wrappings, bags, etc. are disposed of
safely and kept out of the reach of children. Danger of suffocation!
Disposal of an old appliance Old appliances may contain materials that can be recycled. Please contact
your local recycling authority about the possibility of recycling these
materials. Make sure that the appliance presents no danger to children
while being stored for disposal. Before discarding an old appliance, unplug it
from the outlet and cut off its power cord. Remove any doors to prevent
trapping hazards.