Filter
Top Products
EN
Safety Instructions
Warning! Before connecting the
appliance compare the power data
(voltage and frequency) indicated on
the characteristics plate with those
of the power supply in question. If
these data do not match there may
be problems. In case of doubt,
contact an electrician.
Warning! If the electrical wire plug
is removed, the appliance must be
installed and connected by a
technician. Contact a qualified
electrician who knows and respects
current safety standards. The
manufacturer cannot be held
responsible for damage resulting
from fitting or connecting errors.
Warning! The electrical safety of
the appliance can only be
guaranteed if it is earthed. The
manufacturer cannot be held
responsible for damage resulting
from the absence of or defects in the
installation’s protection system (e.g.
electrical shock).
Warning! Only use the appliance
once it has been fitted into its built-in
position. Only in this manner can it
be guaranteed that users cannot
access the electrical components.
Warning! Never open up the
appliance’s frame. Possible contacts
with electrical conducting parts or
changes to electrical or mechanical
components may represent a
danger to users’ safety and
prejudice the correct working of the
appliance.
Warning! Repairs and
maintenance, especially of parts
carrying electrical current, must only
be done by technicians authorised
by the manufacturer. The
manufacturer and retailers do not
accept responsibility for any
damaged caused to people, animals
or property as a result of repairs and
maintenance carried out by non-
authorised personnel.
Warning! Repairs undertaken
during the guarantee period must
only be done by technicians
authorised by the manufacturer. If
this is not the case then any
damage resulting from the repair in
question is excluded from the
guarantee.
Warning! The appliance must be
disconnected from the electrical
current when installation and repair
work is being done. To disconnect
the appliance from the current, one
of the following conditions must
apply:
- The switchboard fuses / circuit
breakers must be disconnected.
- The plug should be removed from
the socket. To remove the plug
from the socket do not pull on the
electric cable but rather pull out
the plug itself directly.