Filter
Top Products
Use only genuine BISSELL replace-
ment filters in your BISSELL vacuum.
To purchase visit WWW.BISSELL.COM
or call 1-800-237-7691.
To clean filter:
1.
Turn power OFF (O).
2. Remove the dirt container from the hand
vacuum, as directed in step 1 "Emptying
the dirt cup" on page 6.
3. Remove filter and tap firmly against the
inside of a waste container, removing
any visible dirt.
4. Replace filter back into the dirt container
and attach dirt container to hand
vacuum until it snaps securely in place.
NOTE: After heavy usage, you may
clean the filter by washing it gently
by hand in warm water and mild
dish detergent. Rinse thoroughly
and make certain it is completely
dry before replacing it.
The brush roll may accumulate debris
such as strings, hair and fibers. This
type of debris can wrap around the
brush and diminish its ability to clean
effectively.
To remove brush roll for cleaning:
1.
Turn power OFF (O). Remove foot
assembly from unit and turn over to
access the brush roll.
2. Remove three Phillips head screws to
remove the belt cover.
3. To remove brush roll, pull on the brush
near the belt side. Clean off hair or
other debris from brush roll.
4. Place cleaned brush roll back into foot
of unit by aligning the non-belt side so
it's seated in the nozzle.
5. Pivot the brush roll so the belt end slides
into the slot in the nozzle.
6. Replace the belt cover and secure with
three screws. Attach foot assembly
on unit.
www.bissell.com 800.237.7691
7
Maintenance and care
3.
4.
Brush roll and brush roll belt maintenance
Cleaning or Replacing the filter continued
2.
3