Black & Decker BX210 Blender User Manual


 
English
-4-
This appliance is not intended for use by
persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been give
supervision or instruction concerning
use of the appliance by a person
responsible for their safety
Children must be supervised to make
sure that they do not play with the
appliance.
This unit must be attended in use
Do not allow children to use the blender
without supervision.
Before first use
Before using the appliance for the first
time ensure all packaging is removed.
Clean all parts before use.
After use
Switch off and remove the plug from the
socket before leaving the appliance
unattended and before changing,
cleaning or inspecting any parts of the
appliance.
When not in use, the appliance should
be stored in a dry place. Children should
not have access to stored appliances.
Inspection and repairs
Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts, damage to switches
and any other conditions that may affect
its operation.
Do not use the appliance if any part is
damaged or defective.
Have any damaged or defective parts
repaired or replaced by an authorised
repair agent.
Before use, check the power supply
cord for signs of damage, ageing and
wear.
Do not use the appliance if the power
supply cord or mains plug is damaged or
defective.
If the power-supply cord or mains plug is
damaged or defective it must be repaired
by an authorised repair agent in order to
avoid a hazard. Do not cut the power
supply cord and do not attempt to repair
it yourself.
Never attempt to remove or replace any
parts other than those specified in this
manual.
Warning symbols
The following symbols are used in this
manual:
Do not immerse the appliance, cord set or
plug in liquids
Denotes risk of personal injury or
damage to the product in case of
non-observance of the instructions in this
manual.
Denotes risk of electric shock.
Electrical safety
This appliance is double insulated in
accordance with EN 60335;
therefore no earth wire is required.
Always check that the power supply
corresponds to the voltage on the rating
To avoid the risk of electric shock,
do not immerse the cord, plug or
motor unit in water or other liquid.
Parts Identification (Fig A)
1 Filler cap 7 Control dial
2 Lid 8 Foot
3 Jar 9 Grater
4 Blade assembly 10 Grinder
5 Seal 11 Grater lid
6 Motor housing 12 Grinder lid