Black & Decker CO100 Can Opener User Manual


  Open as PDF
of 17
 
6
7
GETTINGSTARTED
• Remove all packing material, labels and any stickers.
• Remove and save literature.
• Unpack mounting parts and set them aside in a safe place where they will not
roll away or get lost.
Important:Donotattempttooperateapplianceuntilitisproperlyinstalled.
CHOOSEALOCATION
When choosing your location, consider the following:
• DO make sure to mount within reach of an electrical outlet.
• DO consider your normal work patterns in the kitchen when choosing
location.
• DONOT mount over any heating or cooking appliance such as your range or
oven.
• DONOT mount over or near a sink.
• DONOTmount under, in front of or behind any under-cabinet light fixtures.
Note: If you are mounting multiple †SpaceMaker™ appliances, they should not
be mounted flush to one another. Allow at least 4” of space between appliances
for adequate cooling.
Note: If you are connecting this appliance to the receptacle of another
†SpaceMaker™ appliance such as the toaster oven or coffeemaker, make sure you
can easily unplug the appliance following use.
DETERMINECABINETTYPE
Prior to installation, determine if your cabinet has a flat bottom (B) or an
overhang molding (C). If your cabinet is flat, follow STANDARD INSTALLATION;
if the cabinet has an overhang molding, refer to OVERHANG MOLDING
INSTALLATION.
STANDARDINSTALLATION(FLATCABINET)
Important:Alwayswearprotectiveglassesorgogglestopreventinjurywhen
drilling.
1. Clear countertop under installation area to avoid getting dust or debris on other
appliances or items. Open cabinets and remove contents to make mounting
easier.
2. Clean both the underside and topside of the bottom panel of the cabinet.
B
C
3. With cabinet doors open, place mounting template flush against the surface of
the underside of your cabinet, making sure to align thick line on template with
bottom front edge of your cabinet (D).
Important:Donotalignscrewholesontemplatedirectlyunderthepartition
betweencabinets,asthiswillpreventyoufrominstallingtheapplianceproperly.
Paycloseattentiontowherethedrillholeswillbesetsoasnottodamageyour
cabinetsduringmounting.Drillingthroughyourcabinet’spartitionmaycause
damagetocabinetsandpreventproperinstallation.
4. Fold the template along the edge of your cabinet so the thick line is straight
with bottom front edge; pull template tight and tape down to hold in place.
5. Drilling from under the cabinet up, drill holes through the 4 places marked on
the template, using a ¼-inch drill bit (E).
Important:Alwaysensureyouaredrillingstraightupthroughthemarked
mountingholesonthetemplate.Drillingatananglemaypreventproper
installationandmaydamagecabinetsifthedrillbitpiercesthepartition.
6. Once holes are drilled, remove tape and mounting template.
7. Wipe dust and debris off the topside and underside of the cabinet surface.
8. Place a washer inside the cabinet over each of the 4 holes you drilled.
9. Hold appliance in place, aligning front of unit with front edge of cabinet;
drilled holes on cabinet should be aligned with mounting holes on the unit.
10. Drop one of your screws through each of the washers covering the holes in
the cabinet, from inside the cabinet down.
D
E
 previous next