Filter
Top Products
-4-
ENGLISH
Before first use:
• Before using your Chopper Blender for the first time, make sure it is disconnected from the electrical supply,
then remove all packaging.
• All parts should be cleaned before use.
• Clean all parts as recommended in the section “How to take care of your Chopper/Chopper Blender”
• The motor housing (9) must only be cleaned with a damp cloth, and dried thoroughly before use.
• To clean the Blender jar (3), add 0.5L of warm water and a little detergent to the jar.
• Fit the jar to the Motor housing & connect it to a suitable electrical supply.
• Run the Blender for a few seconds until clean.
• Rinse, repeat & rinse again.
• Dry carefully, taking care when approaching the blades as these are very sharp.
• All other parts can be washed using a mid detergent and warm water. These parts are not dishwasher safe
and must be hand washed.
• After washing, rinse and allow all parts to dry thoroughly before re-assembly and storing.
• Take care when handling the cutting blades as they are sharp.
How to assemble your Chopper (FX350)
• Place the motor housing (9) on a flat, stable surface.
• Place the bowl (7) over the stem on the motor housing.
• Fit the blade (6) over the boss on the bowl. Press down gently to make sure it is locked in place.
• Fit the cover (5) over the bowl; rotate anti-clockwise to lock in place.
Note: The chopper will not work unless the cover is correctly fitted.
How to assemble your Blender (FX350B)
• Place the motor housing (9) on a flat, stable surface.
• Place the blender lid (2) on top of the blender jar; rotate anti-clockwise to lock in place.
• Fit the blender lid cap (1) into the blender lid & rotate anti-clockwise to lock in place.
• Place the Blender jar (3) on the motor housing and rotate it in an anti-clockwise direction until it locks in
place.
Note: The blender will not work unless it is correctly fitted.
How to use your Chopper (FX350)
• This appliance is designed to chop dry ingredients such as meat.
• Do not use this appliance for any other purpose. For indoor domestic use only.
• Prepare the ingredients by cutting them into small cubes and place them in the bowl (7). Do not over-fill the
bowl.
• Fit the cover (5) over the bowl and rotate anti-clockwise to lock in place.
• To avoid a hazard, this appliance must only be used for chopping dry ingredients.
Note: The chopper will not work unless the cover is correctly fitted.
Press the on / off switch (8) down.
• The unit should only be operated for 5 to 15 second pulses only. Never operate the chopper continuously
for longer than 45 seconds at a time. Always allow the appliance to cool down for a minimum of 15 minutes
before next use.
• When the correct consistency is achieved, disconnect the unit from the electrical supply.
• Remove the cover, the blade and then remove the bowl & transfer the ingredients to a suitable container.
• Take care when handling the cutting blades as they are sharp.