Filter
Top Products
1. Your Blade Assembly has been
packed in a separate
cardboard insert. Attach it
to the can opener by
lining up the key tabs
with the key slots,
push in and turn (A)
until it locks into
position.
2. Plug the cord into
a standard, 120-volt
electrical outlet.
3. Lift the Lever, tip the can
so that the rim is under the
Locating Post, then push down on the
Lever, making sure the blade is inside the rim. (B)
Because of the hands-free feature, it is not
necessary to hold the Lever down or
support the can during cutting.
However, you may have to hold
the Can Opener Body when
cutting very tall or heavy cans.
4. When the can is opened,
the Can Opener will stop
automatically. To remove the
can, tilt it slightly away from
the unit with one hand and
raise the Lever with the other.
CAUTION: Avoid contact with
the cut edges of the can or lids —
they are sharp. Carefully remove the
lid from the magnet and discard.
5. Unplug when finished. You may “stuff”
excess cord back into the bottom of the unit and feed the cord through
the notch for convenient storage.
HOW TO USE
4
A
B