Filter
Top Products
8
7
Important: The hood/deflector of the toaster oven is removable to make
installation easier. To remove, pull forward slightly on the hood to release the
front hooks (F). Once front hooks have released, the hooks at the rear will
disengage easily. Once removed, mount hood in place following the directions
below and then reattach the appliance once the hood has been mounted.
8. Hold hood in place, aligning front of hood with front edge of cabinet; drilled
holes on cabinet should be aligned with mounting holes on the hood.
9. Screwing from inside the cabinet down into holes, tighten 4 screws in place to
secure hood to cabinet.
Note: Always tighten screws to ensure the appliance does not move or shake
during operation.
10. Once the hood is secured, lift the toaster oven up, engaging the rear hooks on
the hood first, and then the front.
11. Extra cord can be hung over cord management hook behind unit (G).
Warning: Risk of electrical shock and fire. Do not allow cord(s) to touch rear
surface of oven.
Caution: This appliance features a Save-A-Plug™ outlet receptacle to connect
smaller †SpaceMaker™ appliances such as the mini food processor / grinder or
can opener. Do not use this outlet for any other appliance!
Note: If you are connecting another †SpaceMaker™ appliance into the Save-A-
Plug™ outlet, make sure you can easily unplug the appliance after each use.
12. Your †SpaceMaker™ appliance is now ready for use!
F
G
STANDARD INSTALLATION (FLAT CABINET)
Important: Always wear protective glasses or goggles to prevent injury when
drilling.
1. Clear countertop under installation area to avoid getting dust or debris on other
appliances or items. Open cabinets and remove contents to make mounting
easier.
2. With cabinet doors open, place mounting template flush against the surface of
the underside of your cabinet, making sure to align thick line on template with
bottom front edge of your cabinet (D).
Important: Do not align screw holes on template with the partition between
cabinets, as this will prevent you from installing the appliance properly. Pay
close attention to where the drill holes will be set so as not to damage your
cabinets during mounting. Drilling through your cabinet’s partition may cause
damage to cabinets and prevent proper installation.
3. Once thick line is straight with bottom front edge, pull template tight and tape
down on all 4 corners to hold in place.
4. Drilling from under the cabinet up, drill holes through the 4 places marked on
the template, using a ¼-inch drill bit (E).
Important: Always ensure you are drilling straight up through the marked
mounting hole on the template. Drilling at an angle may prevent proper
installation and may damage cabinets if the drill bit pierces the partition.
5. Once holes are drilled, remove tape and mounting template and save template
with your instructions in case you move or wish to remount at a later time.
6. Wipe dust and debris off inside cabinet surface. Also, make sure under-side of
cabinet is clean.
7. Place a washer inside the cabinet over each of the 4 holes you drilled.
D
E