Filter
Top Products
BLODGETT
www.blodgett.com
1100 Old Honeycutt Road Fuquay-Varina, NC 27526 USA • Phone: (877) 255-3976 • Fax: (866) 644-1354
MODEL B48-CCCC
SHORT FORM SPECIFICATIONS
The item shall be a 48"-wide front-manifold sectional range with full width charbroiler with four 32,000 BTU sections, cast iron removable grates, and an operating surface temperature of
up to 725°F. The item shall have a 7" front rail and a belly bar. The item shall have 6" adjustable legs [casters]. The item shall have a [5" 24" 36"] flue riser able to support 250 pounds.
The exterior (except for the back) shall be constructed of 430 stainless steel #3 polish. If the item is at the end of a battery, the end side shall be solid (rather than have a coverplate over
the end of the front manifold).
Model 48A: The item shall have a 12” wide cabinet and 36” wide, 45,000 BTU convection oven with standing pilot and a thermostat range of 150°F to 550°F (66°C to 288°C). The oven
interior shall be porcelain, measure 14" high x 26" wide x 24" deep, and have two racks with five-position side-rails with 2-1/4" between positions. The blower fan shall have two speeds
and a 1/3 hp motor.
Model 48D: The item shall have a 12” wide cabinet and 36” wide 45,000 BTU standard oven with standing pilot and a thermostat range of 150°F to 550°F (66°C to 288°C). The oven
interior shall be porcelain, measure 14" high x 26" wide x 26.5" deep, and have two racks with five-position side-rails with 2-1/4" between positions.
Printed in U.S.A. NOTE: FOR COMMERCIAL USE ONLY
NOTE: The company reserves the right to make substitutions of components without prior notice
APPROVAL/STAMP
P/N BR00014 Rev D (6/08)
OTHER TECHNICAL INFORMATION
Exterior surfaces are 430 stainless steel #3 polish, except the back is aluminized steel.
Each 12” section has a separate control knob located on the front panel. On oven models, a gas valve for the oven is located on the front panel above the oven. The oven control panel
is located to the left of the oven door and includes an on-off switch, indicator light, thermostat knob, and (on convection ovens) a speed selector switch for the blower motor. The fan
motor for convection ovens is 1/3 hp, 2-speed, 1725/1140 rpm, with overload protection. Check local codes for fire and sanitary regulations.
UTILITY INFORMATION
GAS: Each unit has a 1-1/4" front gas manifold that couples to the adjacent sectional unit(s), and can be
ordered with a 1" rear gas connection with a male NPT connector. Minimum supply pressure is 7" W.C. for
natural gas, 11" W.C. for propane. An external pressure regulator and shut off valve must be provided. If
using a flexible-hose gas connection, the I.D. of the hose must not be smaller than the connector on the unit
and must comply with ANSI Z21.69. Provide an adequate means of restraint to prevent undue strain on the
gas connection.
ELECTRICITY: Both standard-oven and convection-oven models require electric power (50Hz or 60Hz single-
phase AC). 120V models have a 7-foot (2134 mm) power cord with a grounded plug. 208/240V models have
a terminal block for connection to a single-phase 208/240V source.
FLUE EXHAUST: Installation under a vented hood is recommended.
MODEL
GAS (BTU/hr) ELECTRICITY (amp)
Natural Gas Propane 120V 208/240V
B48A-CCCC 173,000 154,000 4.8 2.6
B48D-CCCC 173,000 154,000 1.0 1.0
B48N-CCCC 128,000 112,000
- -
Flue riser for “deep” depth-option extends rearward 6”
(cooking surface area is same as for “standard”depth).
Minimum clearance from noncombustible construction is zero.
SHIPPING CRATE DIMENSIONS & WEIGHT
(Door entry clearance when uncrated is 38” for all models,
except convection ovens, which is 41”.
The flue riser is installed on-site)
Model Width Height Depth Volume Weight
B48A-CCCC
B48D-CCCC
B48N-CCCC
45.5
(1156)
45.0
(1143)
55.0
(1397)
65.2 cu ft
(1.85 cu m)
621 lbs
(281 kg)
45.5
(1156)
45.0
(1143)
55.0
(1397)
65.2 cu ft
(1.85 cu m)
568 lbs
(257 kg)
45.5
(1156)
55.0
(1397)
23.0
(584)
33.3 cu ft
(0.95 cu m)
276 lbs
125 kg)
Dimensions are in inches and (millimeters)
SIDE VIEW of MODULAR MODEL
8-1/2” (216)
SIDE VIEW
41-3/4” (1060)
38” (965)
2-1/2” (64)
Front Gas
Manifold
35-3/4” (908)
32” (813)
33-3/4”
(859)
15-3/4”
(400)
Motor for
Convection
Oven Model
REAR VIEW
2-1/2" (64)
7" (178)
Rear Gas
Manifold
20”
(508)
18”
(457)
Electrical
Connection
for Oven
Models
TOP VIEW
38-3/4”
(984)
24”
(610)
7” (178)
2” (51)
36” Flue Riser
24” Flue Riser
48” (1219)
36”
(914)
41”
(1041)
60”
(1524)
72”
(1829)
5” Flue Riser
FRONT VIEW