Filter
Top Products
Installation
5
Oven Assembly
ALIGNING THE DOCKING MECHANISM
1. Open the oven doors fully.
2. Move and latch the transport cart into place a t
thefrontoftheoven.Thetwoalignmentpins
on the front of the cart should line up with the
channeled openings in the docking assembly.
The l ocking bar also locks to the docking as-
sembly.
3. Align the inner vertical edge of the tracks on
the transport cart with the same vertical edge
of the tracks located on the oven liner floor.
This adjustment can be made by moving the
docking assembly either left or right. Tighten
the four bolts with a wrench.
4. Level the tracks on the transport cart to the
same height as the tracks on the oven liner
floor. This adjustment is made by raising or
lowering the nuts on the four levelling screws
located on each corner of the transport cart.
5. When the transport cart locks properly to the
front of the oven the unit is ready for loading
operation.
Locking Bar
Alignment Pins
Transport
Cart Tracks
Transport
Cart Tracks
Figure 3