Blomberg DW 54100 W Dishwasher User Manual


 
17
USA
8. SETTING THE WATER SOFTENER (MODEL DEPENDING)
1. Press the Program Selection button before you switch the appliance on and keep this
button pressed down.
2. Switch the appliance on using the On/Off button; then release the switch.
3. Release the Program Selection button when the water hardness level stored on your
machine is displayed in “r…..” format.
4. Start / Stop icon will start flashing as soon as the water hardness level stored on your
machine.
5. Water hardness can be set to the desired level by pressing the Time Delay button
(compare the test strip with the degrees of Hardness Table). The appropriate program
follows up lights up.
6. Once you have set the hardness level, press the Start/Stop/Cancel button to save the
value. The control indicator on the Start/Stop/Cancel button now lights up permanently.
7. Switch the appliance off again using the On/Off button.
WATER HARDNESS TABLE
Notice :
If the water hardness level is less than 7 American degree of hardness, you do not need any
special softening salt. In this case the ‘salt’ control indicator lights up continually.
If your local hardness level exceeds 47 American degree of hardness, you should consider
getting a water softening device for your dishwasher. If you use stream water or rainwater,
you are advised to install filters.
If you move do not forget to adjust the water hardness level to suit your new neighborhood.
If the model does not have a salt dispenser ignore this changes. Water hardness level must
in position 1.
a b c d e f
Remove the test
strip from the packet.
Turn on the tap and
let the water run for
about a minute.
Hold the test strip in
the water for about a
second.
Remove the test strip
from the water and
shake it.
Wait for 1 minute. The test strip shows
you the hardness
level.
1 Second
1 Minute
1 Min.
Name of unit American PPM German
Indicator in the Multi-Function Display
Definition
1 grain of CaCO
3
/
1 gal (US) of water
1 mg of CaCO
3
/
1 L of water
10 mg of CaO/
1 L of water
1
st
Level
0-6 0-105 0-5
Press the Time Delay button to switch
the water hardness level to position 1.
2
nd
Level
7-12 106-210 6-11
Press the Time Delay button to switch
the water hardness level to position 2.
3
rd
Level
13-18 211-320 12-17
Press the Time Delay button to switch
the water hardness level to position 3.
4
th
Level
19-23 321-409 18-22
Press the Time Delay button to switch
the water hardness level to position 4.
5
th
Level
24-36 410-624 23-34
Press the Time Delay button to switch
the water hardness level to position 5.
6
th
Level
37-47 625-804 35-45
Press the Time Delay button to switch
the water hardness level to position 5.