Filter
Top Products
12
USA
12. Allow your dishes to cool for 15 minutes,
with the door open.
13. Unload the dishes. Begin with the lower
rack.
CAUTION
Avoid opening the door during the
washing process. This interrupts the
washing process, and hot steam will
escape. Hot steam can cause burns and
other serious injuries. When the door is
closed, the program will continue.
FUNCTION BUTTONS
ON/OFF BUTTON
Turn the dishwasher on with the
On/Off button. When turning on,
the icon on the display module of
the last used program will light up.
PROGRAM SELECTION
BUTTON
Use the Program Selection
button to select the desired
program. The icon of the corresponding
program will light up.
Refer to “Table of Programme Data and
Average Consumption Values” to select a
programme suitable for your dishes. Select
the desired programme with programme
selection button.
6. OPERATING THE DISHWASHER
Reset.
3 sec.
Reset.
3 sec.
1 On/Off button
2 Half Load indicator led
3 Salt level indicator led *
4 Start/Pause/Cancel indicator led
5 Start/Pause/Cancel button
6 Time Delay button
7 Time Delay indicator led
8 Rinse aid level indicator led
9 Remaining Time Indicator/Delay Time
Indicator
10 Tablet Detergent indicator
11 Program Indicator
12 Half Load/Combi Tablet button
13 Program Selection buton
(* Model depending)
HOW TO USE YOUR DISHWASHER:
1. Open the door and load the dishwasher.
2. Check that both upper and lower spray
arms move freely.
3. Pour correct amount of detergent into the
detergent dispenser and close the lid.
4. Push in the On/Off button 1 and check
that the display lights come on.
5. Check the rinse aid level indicator led. 8
If necessary, refill rinse aid.
6. Check the salt level indicator led. 3 If
necessary, refill salt. (model depending)
7. Use the Program Selection button 13 to
choose your washing program.
- When there are few dishes, additionally
use the Half Load function.
- Depending on the hardness level of
the tap water, the Tablet Detergent
function allows better drying and washing
performance from the multi-purpose tablets.
8. Start the program with the Start/Pause/
Cancel button 5.
9. Close the door and the program will start.
10. When the wash program has ended, an
electronic beep will sound and will continue
every 10 seconds. After 2 minutes of
elapsed time the sound will stop. The beep
can also be stopped by opening the door or
by pressing the On/Off buton 1.
11. Press the On/Off button 1 and open the
door after the program is completed. The
indicator lights will go off.