Blomberg FINE 1531P Freezer User Manual


 
EN
8
food in the freezer will not defrost
even if the ambient temperature falls
as low as -15 °C. When first installed
the product MUST NOT be placed in
low ambient temperatures because
the freezer will not reduce to it’s
standard operating temperature. Once
it has reached its steady operating
state it can be re-located. So you
may then install your appliance in a
garage or an unheated room without
having to worry about frozen food in
the freezer being spoilt. However at
low ambient temperatures mentioned
above, fridge contents are likely
to freeze, so check and consume
food in the fridge accordingly. When
the ambient temperature returns to
normal, you may change the knob
setting to suit your needs.
4.No gap is required at sides and top.
See item 4 below to ensure a gap is
obtained at the rear of the appliance.
If a gap is available on side and
top, retain it if possible as it would
improve the air circulation around the
appliance.
5. The appliance should be located on
a smooth surface. The two front feet
can be adjusted as required. To ensure
that, your appliance is standing upright
adjust the two front feet by turning
clockwise or anti-clockwise, until the
product is in firm contact with the
floor. Correct adjustment of feet avoids
excessive vibration and noise.
6. Refer to “Cleaning and Care”
section to prepare your appliance for
use.
7. A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back of
the cabinet, on the right hand side of
1
2
3
3
3
1
If your appliance is equipped with an air
grille, please refer for installation of the air
grille.
the compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage.