Blomberg IWD 1004 XT Freezer User Manual


 
EN
18
Prior to first use of Ice/Water
Dispenser
C Water mains pressure must not be
below 1 bar.
C Water mains pressure must not be
over 8 bars.
you will have to connect a standard 1/2”
valve connection fitting to the cold water
supply in your house. In case this valve is
not present or in case you are not sure,
consult a qualified plumber.
1. Separate the union from the tap
adaptor. (Figure A)
2. Install the tap adaptor to 1/2” valve
fitting as shown in the figure. (Figure B)
3. After inserting the water pipe to the
union, install it to the tap adaptor and
insert to the tap as shown in the figure.
(Figure C)
4. Tighten the union manually. In case of a
leak use a spanner or a pair of pliers to
tighten the union.
A Warning: Secure the water pipe
to suitable points by means of the
pipe clips supplied to avoid any
damage or displacement or accidental
disconnection.
A Warning: After turning on the water
valve, make sure that there is no leakage
at both connection points of the water
pipe. In case of a leak, turn off the valve
immediately and tighten all joints again
using a spanner or a pair of pliers.
A Warning: Make sure that standard
1/2" valve fitting fed by cold mains water
supply is available and is turned off fully.
Note -1: There is no need to use water
filter in case a jug is used.
Note -2: Pump must be used when jug will
be used.