Filter
Top Products
INSTALLATION INSTRUCTIONS
READ THIS CAREFULLY BEFORE STARTING THE INSTALLATION
Unpack the unit. Inspect all components for completeness and
condition. Ensure that all packing materials have been removed
from the unit.
Verify that the Spray Head Gasket and Spray Disk are properly
installed.
LEVELING THE UNIT
Verify that slip-resistant foot is installed at each corner of the
warmer.
Set warmer in its operating location. Level the warmer. A spirit
level should be placed on the top of the unit, at the edge, as a
guide when making level adjustments.
ELECTRICIAN’S INSTALLATION INSTRUCTIONS
REFER TO ELECTRICAL SPECIFICATIONS - Page 1
Check the nameplate to determine correct electrical service
required for the Brewer to be installed.
Warmer models 8708, 8851, 8852, 8871 and 8872 are
equipped with a cord and plug. They require a 115 - 125 volt
15 amp circuit (50/60 Hz, 2 wire plus ground, with NEMA 5-15R
receptacle).
CAUTION:
EQUIPMENT DAMAGE
DO NOT plug in or energize this
appliance until all Installation
Instructions are read and
followed.
Damage to the Brewer will occur
if these instructions are not
followed.
CAUTION:
UNSTABLE
EQUIPMENT HAZARD
It is very important for safety and
for proper operation that the
brewer is level and stable when
standing in its final operating
position. Provided adjustable,
non-skid legs must be installed at
each corner of the unit.. Failure to
do so will result in movement of
the brewer which can cause
personal Injury and/or damage to
brewer.
WARNING:
SHOCK HAZARD
Brewer must be properly
grounded to prevent possible
shock hazard. DO NOT assume
a plumbing line will provide such
a ground. Electrical shock will
cause death or serious injury.
IMPORTANT:
The ground prong of the plug is
part of a system designed to
protect you from electrical shock
in the event of internal damage.
Never cut off the ground prong
nor twist a blade to fit an
existing receptacle. Contact a
licensed electrician to install the
proper circuit and receptacle.
4
763 p/n 77719 OpManual Decanter Warmers