Bodum 10713 Coffee Grinder User Manual


 
2
C-MILL
Welcome to BODUM
®
Congratulations! You are now the proud owner of a C-Mill
coffee grinder, the electrical blade coffee grinder from BODUM
®
.
Read these instructions carefully before using the coffee grinder.
IMPORTANT SAFEGUARDS
This BODUM
®
coffee grinder is intended for grinding coffee beans for
domestic use only. Do not use to grind anything else as this would
damage the appliance.
Before operating this appliance for the first time, read all instructions.
Failure to observe the instructions and safety notes may result in
hazardous conditions.
After unpacking the appliance, check it for damage. If in doubt, do
not use it, contact your dealer.
– Keep the packaging materials (cardboard, plastic bags etc.) out of
reach of children (danger of suffocation or injury).
This appliance is designed for household use only. Do not use outdoors.
Do not place on or near a hot gas or electric burner, or in a heated
oven.
The manufacturer rejects any liability for damage or injury caused by
improper or unreasonable use. Do not use appliance for other then
intended use.
Do not allow children to play with the appliance.
Close supervision is necessary when any appliance is used by or near
children or not familiar persons.
To use the appliance, it must be plugged into a power point. Never use
the appliance on a hot surface.
Never touch the appliance with damp or wet hands. Do not touch the
mains cable or plug with wet hands. Always unplug the appliance by
holding the plug, not the cord. Do not let cord hang over edge of
table or counter, or touch hot surfaces. Do not operate any appliance
with a damaged cord or plug or after the appliance malfunctions, or
has been damaged in any manner.
The use of accessory attachements not recommended by the appliance
manufacturer may result in fire, electric shock or injury to persons.
– This appliances has a polarized plug (one blade is wider than the
other). To reduce the risk of electric shock, this plug will fit in a
polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not modify the plug in any way.
05_10713_C_MILL.qxp 31.7.2007 9:19 Uhr Seite 2