Filter
Top Products
OPERATION
4.
Note: To manually interrupt the boiling process, press the on/of button at any
time, Heater and LED lights will shut o.
Selecting Water Temperature Hold:
This feature allows the Kettle to reach and maintain water at a set temperature for
up to one hour. This is an optional setting.
First select the Shut o temperature using above steps.
Press the hold button, the last set Hold temperature will ash on the display for 3
seconds and the hold indicator LED light is lit. (ill. E).
When set temperature is reached the heater will turn heating o and on as needed
to maintain set temperature. The power on indicator light is on and the LED
displays the current water temperature.
When you lift kettle to pour and return to the base, the Hold button must be
pressed again within 5 seconds if you want to continue the Hold Temperature
function. If you don’t press the Hold button within 5 seconds of returning to base
the display will show current water temperature for 7 minutes and then the unit
will power o.
Note: To manually interrupt the boiling process, press the on/of button at any
time, Heater and LED lights will shut o.
•
•
•
•
•
Note: If kettle is removed from base during heating cycle the Heating cycles shuts
o and Power On Indicator Light (11) goes o, and LED display “0 00”. When the
kettle is returned to base the Display it will show current water temperature for
7 minutes and then the display will shut o.
High Altitude Users
Water boils at lower a temperature at higher elevations, according to the below graph
to set your kettle brewing temperature
Count Up Timer Feature:
Note: when you lift the kettle, the LED display will Display the count-up timer. The rst
number indicator the minutes, and the last two number indicator the seconds (the
maximum count time is 7 minutes). Press the + button to start the timer. Set the kettle
back on the base and lift back o to reset timer to zero.
WARNING: The appliance is very hot during use. Do not touch kettle surface. Danger
of burns!
minutes
seconds