Filter
Top Products
PAGE 4
Hood Surface
Painted Surfaces:
For general care, wipe the outside of the hood with sudsy
water or household cleaners such as Fantastic
®
or Formula
409
®
, rinse well and dry with a clean soft cloth to avoid water
marks.
Stainless Steel Surfaces:
Wipe and dry stainless steel in the same direction as the
grain. Avoid using too much pressure, which may mar the
surface.
To remove finger prints and give added shine, use spray
cleaners such as Stainless Steel Magic
®
.
Do not allow any cleaning compounds to remain in contact
with stainless steel for extended periods.
Care, Cleaning and Maintenance
Filters
The hood has removable aluminum filters that must be
cleaned when they collect grease.
The filters can be cleaned with soap and water or in the
dishwasher.
DAH95 models are equipped with a filter light that will
illuminate after 40 hours of operation. The light indicates
that the filters need to be cleaned.When used over a wok
or other high grease application, more frequent cleaning
may be required.
Remove the filters for cleaning: push the handle in and
pull down. The front will come out first. Then pull the
back down and out. See Figure 2.
Do not use cooktop while hood is disassembled
.
1
Lights
NOTE: Turn off the lights and fan and allow lights to cool
before handling. If lights do not operate upon installation,
check for proper insertion. Light bulbs can be cleaned with
soap and water.
Light Bulb Replacement
Remove the damaged light bulb by turning counter-clockwise.
Replace with a new 50W flood light bulb. Models DAH95
and DAH94 use a Par 20 halogen light bulb. Model DAH93
requires a R20 incandescent bulb. Follow package
directions.
WARNING
Be sure the entire hood (including the filters and light
bulbs) has cooled and grease has solidified before
attmepting to clean any part of the appliance.
Buttons
Wipe with sudsy water or household cleaners such as
Fantastic
®
or Formula 409
®
, rinse well and dry with a clean
soft cloth to avoid water marks.
CAUTION
DO NOT TOUCH THE BULBS IMMEDIATELY
AFTER USE.
THE BULBS WILL REMAIN HOT FOR
SEVERAL MINUTES.
DO NOT use the following!
Do not use the following cleaning agents on any of the
hood components:
Abrasive Pads such as those made from steel wool
(SOS
®
, Brillo
®
) or plastic mesh.
Abrasive cleaners such as Comet
®
, Ajax
®
and Zud
®
.
Flammable products such as gasoline or kerosene.
Figure 2 - Filters